Missing DLL....

widewings · Post by **widewings** » Fri Jan 27, 2012 2:12 pm

I have a USB DVB-S. Whenever I run the bundled application it is looking for a dll. That dll is located on the directory of the program I don't know why it can't see it. I also loaded the driver for linux just to be safe. Copied that dll to System32 folder.

Any suggestion would be much appreciated.

jjmckenzie · Post by **jjmckenzie** » Fri Jan 27, 2012 2:36 pm

On Fri, Jan 27, 2012 at 12:12 PM, widewings <[email protected]> wrote:

I have a USB DVB-S (http://www.tevii.com/Products_S630_1.asp). Whenever I run the bundled application it is looking
for a dll. That dll is located on the directory of the program I don't know why it can't see it. I also loaded the driver for
linux just to be safe. Copied that dll to System32 folder.

USB devices other than mass storage devices are not supported at this time.

http://wiki.winehq.org/USB

may or may not be of assistance.

James

John Drescher · Post by **John Drescher** » Fri Jan 27, 2012 2:48 pm

Any suggestion would be much appreciated.

I would seek a linux native solution for this device. I am not talking
about the vendor software however if there is a linux driver for your
HW there are linux native programs that can use these type of devices.

John

widewings · Post by **widewings** » Fri Jan 27, 2012 3:12 pm

Thanks a lot.

Linux software for this is not just as user friendly as windows but that will do.