'internet explorer only' program error
'internet explorer only' program error
i have a dvr system in the office and it is an 'internet explorer only' program. i have installed i.e7 in wine and am trying to run the program. it goes to the login page and then gives an error 'activeX controls not registered'. i cant figure what this means and how to overcome that. anybody has any suggestions?
Re: 'internet explorer only' program error
What app, and what version of Wine? If it's older than 1.2, upgrade. If it doesn't work in 1.2 or later, post terminal output. http://wiki.winehq.org/FAQ#run_from_terminalnagaraj wrote:i have a dvr system in the office and it is an 'internet explorer only' program. i have installed i.e7 in wine and am trying to run the program. it goes to the login page and then gives an error 'activeX controls not registered'. i cant figure what this means and how to overcome that. anybody has any suggestions?
i am using latest wine. i have started a thread in ubuntuforums as well
http://ubuntuforums.org/showthread.php?t=1564976
.i have added a screen shot there. ( could not upload screenshot here).
nagaraj
http://ubuntuforums.org/showthread.php?t=1564976
.i have added a screen shot there. ( could not upload screenshot here).
nagaraj
Your screenshot cannot be seen by anyone without an Ubuntu forum account.nagaraj wrote:i am using latest wine. i have started a thread in ubuntuforums as well
http://ubuntuforums.org/showthread.php?t=1564976
.i have added a screen shot there. ( could not upload screenshot here).
nagaraj
Where is the terminal output?
sorry,
i am all foggy about the terminal output. this is not a program that is on the native disk. the dvr system acts a s a server and all that i am supposed to do is start internet explorer and point it to the server. the program is supposed to run inside internet explorer as a back-end program. so i dont know how to start it from the command line. moreover i dont know how to attach the screenshot picture here.
i am all foggy about the terminal output. this is not a program that is on the native disk. the dvr system acts a s a server and all that i am supposed to do is start internet explorer and point it to the server. the program is supposed to run inside internet explorer as a back-end program. so i dont know how to start it from the command line. moreover i dont know how to attach the screenshot picture here.
