I wanted to buy a temperature datalogger. So I rang the company concerned helpline and they said yes it'll be fine the configuration file is a txt file on the USB device and although it comes with software you won't need it. I bought it and got it yesterday. Not true of course.
So installed WINE and installed the software off their CD for the logger. Installs and runs fine using WINE 5 windows 7 on mint 20. Used default prefix /.wine
The problem is the device is still not recognized by the software provided which as I say runs fine. I don't have a copy of windows.
dmesg -w gives
After searching around I tried this.
[ 3562.109419] usb 1-2: new full-speed USB device number 11 using xhci_hcd
[ 3562.261761] usb 1-2: New USB device found, idVendor=10c4, idProduct=ea61, bcdDevice= 1.00
[ 3562.261767] usb 1-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 3562.261771] usb 1-2: Product: Temper DataRecorder
[ 3562.261774] usb 1-2: Manufacturer: CEM
[ 3562.261776] usb 1-2: SerialNumber: ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ
[ 3562.263115] cp210x 1-2:1.0: cp210x converter detected
[ 3562.263331] cp210x 1-2:1.0: failed to get vendor val 0x370b size 1: -32
[ 3562.263338] cp210x 1-2:1.0: querying part number failed
[ 3562.263624] cp210x ttyUSB0: failed get req 0x4 size 2 status: -32
[ 3562.263639] cp210x: probe of ttyUSB0 failed with error -32
This worked so I have a symbolic link between ttyUSB0 and com1.
I installed minicom and set up (as sudo) the port as com1 and gave it a run name as logger. Running minicom logger doesn't connect. I also went into REGEDIT and setup a serial device called com1.
I added serial and dialup to my group
ls -l ~/.wine/dosdevices/ now gives
So I've setup a symbolic link to com1. It has rw permissions but when I looked at ttyUSB0 there is a no com1 device error.
ls -l ~/.wine/dosdevices/
total 0
lrwxrwxrwx 1 nrh1 nrh1 10 Oct 5 14:34 c: -> ../drive_c
lrwxrwxrwx 1 nrh1 nrh1 12 Oct 6 10:41 com1 -> /dev/ttyUSB0
etc
The existing error when I plug the data logger in is still there and when I run wincfg and click on drives autodetect the following error shows in the terminal
Is there any solution to this? Its very frustrating that the software itself (which is basic) runs under wine but I cannot find away of connecting to the logger.wine: Read access denied for device L"\\??\\F:\\", FS volume label and serial are not available.
Thanks hhead