jkfloris wrote: ↑Fri Jan 24, 2020 3:09 pm
Which version of FlexiSign Pro do you use?
I'm running 8.1v1 Same that is mentioned on the page I mentioned above. This is all very strange. I can explain a bit more if it helps and you are unfamiliar with FlexiSign. In Flexisign, you have the main program where you create the designs and then you have the production manager which is a separate program. When the design is finish, you click the cut button which sends the design to the production manager. When this happens the first time, a dialog window pops up and asks how to connect to the production manager. The option I use is either 'on the network' or 'by name (ip address)'. When I do this the first time, the design is sent to the production manager and all is well.
After this initial run, I close down Flexisign main program and then reopen it and try to send to the production manager as before and I get the error mentioned in my original post.
I've tried copying my Flexisign directory immediately after installing to a temp directory and then ran through the process once and then it breaks. I then compared those two directories with FreeFileSync and found a config file that was reported as changed. I copied the config file from the temporary directory in hopes it would 'fix' the problem but it did not.
Thanks for helping troubleshoot.