graphics not being rendered correctly

[Iain Mcmurchy]

I've been using Circuit Wizard for some time. It's been perfect up to an including 1.3.34. However, all subsequent versions since 1.3.35 have had incorrect rendering. For example the symbol for a resistor is only showing one wire connector whereas it should be showing two, one at each end of the resistor.

Seems like a regression to me maybe something to do with the DIB engine.

Any suggestions.

I'm using slackware 14.00.


Iain

[dimesio]

Do "all subsequent versions" you've tested include 1.5.19? If not, test in 1.5.19. If the problem is still present in current Wine, run a regression test and file a bug. http://wiki.winehq.org/RegressionTesting

Is there a reason you waited a year to report this?

[Iain Mcmurchy]

I've so far tested up to and including 1.5.18. Will give 1.5.19 a try. I've tested on ubuntu 12.04 and slackware 14.0 both show the same problem.

A bit embarrassing that it's taken me a year to upgrade to a version that shows the problem. Can only blame being too busy on other projects. Though now I've got plenty of time on my hands having just left work


Regards Iain

[Iain Mcmurchy]

I've created a bug report -

Bug 32444 - Incorrect graphic rendendering when using Circuit Wizard

In it I've also reported that the incorrectly rendered circuits still function and print correctly.


Iain